A user-friendly troubleshooting tester
Designed to meet most voltage and continuity applications. The tester automatically turns on when the probes are placed across a complete circuit. The tester selects continuity or dc or ac voltage mode based on the resistance or voltage between the probes. The tester automatically turns off when you remove the probes from the complete circuit. Unit also features non-contact voltage detection.
 

Function

Range

Accuracy

AC Voltage (50/60Hz)

24V, 120V, 208V, 240V, 277V, 480V, 600V

-30% to 0% of reading

DC Voltage

6V, 12V, 24V, 36V, 48V, 110V, 220V

-30% to 0% of reading

Non-contact Voltage Detection



 

To check for the presence of AC voltage at an outlet, using the NCV LED, insert either probe tip into the outlet's hot side. If the black probe is used not only will the NCV LED illuminate but some of the LED's on the front of the instrument will illuminate also. In this application these LED's won't indicate the correct voltage and should be ignored.

Continuity Test

Audible threshold 0 to 85kΩ, Continuity beeper 2kHz

Maximum Voltage

600V Overvoltage Category III (Between any Terminal and Earth Ground)

Input Impedance

1MΩ

Operating Temperature

5°C to 40°C

Storage Temperature

-30°C to + 60°C

Relative Humidity

80% for temperature up to 31°C decreasing linearly to 50% R.H. at 40°C

Power Supply

Two 'AA' batteries type NEDA 15F or IEC R6

Battery Life

350-hours if types NEDA 15F or IEC R6 are used

Safety

Complies with EN 61010-1:1993 for use in overvoltage CAT III environments.

Pollution Degree

2

EMC Regulations

EN 50081-1, EN 50082-1