 |
More detailed power
quality analysis capability, and a new Fluke-patented energy
monetization function
The new 430 Series II
Power Quality and Energy Analyzers offer the best in power quality
analysis and introduce, for the first time ever, the ability to
monetarily quantify energy losses.
The new Fluke 434, 435
and 437 Series II models help locate, predict, prevent, and
troubleshoot power quality problems in three-phase power
distribution systems.
Additionally, the
Fluke-patented energy loss algorithm, Unified Power Measurement,
measures and quantifies energy losses due to harmonics and unbalance
issues, allowing the user to pinpoint the origin of energy waste
within a system. |
Overview
- Energy Loss Calculator: Classic active and reactive power
measurements, unbalance and harmonic power, are quantified to
pinpoint true system energy losses in dollars (other local
currencies available).
- Power Inverter Efficiency: Simultaneously measure AC
output power and DC input power for power electronics systems using
optional DC clamp.
- PowerWave Data Capture: 435
and 437 Series II analyzers
capture fast RMS data, show half-cycle and waveforms to characterize
electrical system dynamics (generator start-ups, UPS switching
etc.).
- Waveform Capture: 435
and 437 Series II models capture
100/120 cycles (50/60Hz) of each event that is detected in all
modes, without set-up.
- Automatic Transient Mode: 435
and 437 Series II analyzers capture
200kHz waveform data on all phases simultaneously up to 6kV.
- Fully Class-A Compliant: 435
and 437 Series II analyzers
conduct tests according to the stringent international IEC
61000-4-30 Class-A standard.
- Mains Signaling: 435
and 437 Series II analyzers
measure interference from ripple control signals at specific
frequencies.
- 400Hz Measurement: 437
Series II analyzer captures power quality measurements for
avionic and military power systems.
- Troubleshoot Real-Time: Analyze the trends using the
cursors and zoom tools.
- Highest Safety Rating in the Industry: 600V CAT IV, 1000V
CAT III rated for use at the service entrance.
- Measure All Three Phases and Neutral: With the included
four flexible current probes with enhanced thin flex designed to fit
into the tightest places.
- Automatic Trending: Every measurement is always
automatically recorded, without any set-up.
- System-Monitor: Ten power quality parameters on one
screen according to EN 50160 power quality standard.
- Logger Function: Configure for any test condition with
memory for up to 600 parameters at user defined intervals.
- View Graphs and Generate Reports: With included analysis
software.
- Battery Life: Seven hours operating time per charge on
Li-ion battery pack.
|
