Fluke i2000 flex AC Flexible Current Clamp

	*Model i2000 flex*
	Accessory Index > Current Clamp Index >

	Model i2000 flex 2000 Amp AC Flexible Current Clamp

Model i2000flex Features

For use with DMM's, Oscilloscopes, ScopeMeters and Power Quality Analyzers

The i2000flex is a flexible, ac current probe for oscilloscopes and digital multimeters recommended for current measurement on large and difficult to reach conductors or grouped cables.

Model i2000 flex 2000 Amp AC Flexible Current Clamp

Features

Measures up to 2000A ac.

Switchable between 200A and 2000A.

Includes a 62 cm (24.4") circumference flexible probe with a connector for coupling and decoupling around a conductor.

Includes BNC connector, making it suitable for use with any oscilloscope, power analyzer or ScopeMeter test tool having a compatible BNC input connector.

Dual banana to BNC adapter is included for use with DMMs.

CAT III 600V.

The output signal is 10 mV/A in the 200A range and 1 mV/A in the 2000A range.

Bandwidth (-3dB): 1 Hz to 20 kHz.

9V alkaline battery, installed.

At least 100 hour battery life.

One year warranty.

UL approval is pending.

Technical Specifications
Nominal Current Range	200 Amps 2000 Amps
Continuous Current Range	2 Amps to 200 Amps 20 Amps to 2000 Amps
Maximum Non-Destructive Current	4000 Amps
Lowest Measurable Current	2 Amps
Basic Accuracy	1% full scale (48Hz to 65 Hz) (% of reading + floor-spec)
Useable Frequency	1 Hz to 20 kHz
Output Level(s)	10mV/Amp 1mV/Amp
Safety	CAT III, 600 Volts
Maximum Voltage	600 Volts AC

General Specifications
Warranty	One year
Maximum Conductor Diameter	160mm
Output Cable Length	2.3 meters
BNC Adapter	Yes
BNC to Banana Adapter Included	Yes
Battery Life	9 Volt greater than 100-hours