Model i30 Features

i30 AC/DC Current Clamp for use with Multimeters, Recorders and other suitable recording instruments.
 

Features

• The i30 current clamp is based on Hall Effect technology for use in measurement of both DC and AC current. The i30 may be used in conjunction with multimeters, recorders and other suitable recording instruments for accurate non-intrusive current measurements.

Technical Specifications

Current Range

20 Amps AC rms or DC

Measuring Range

±30 Amps

Output Sensitivity

100mV/A

Accuracy (at 25°C)

±1% of reading ±2mA

Resolution

±1 mA

Load Impedance

> 10KΩ and ≤100pF

Conductor Position Sensitivity

±1% relative to center reading

Frequency Range

DC to 20kHz (-0.5db)

Temperature Coefficient

±0.01% of reading/°C

Power Supply

9 volt Alkaline, MN1604/PP3, 30 hours, low battery indicator.

Working Voltage

300 Volts AC rms or DC (see Safety Standards section)

Safety Standards

Safety Standards

BS EN 61010-1: 2001
BS EN 61010-2-203: 2002
BS EN 61010-031: 2002
300 Vrms, Category III, Pollution Degree 2
Use of the probe on uninsulated conductors is limited to 300 volts ACrms or DC and frequencies below 1kHz.

EMC Standards

EN 61326: 1998 +A1, A2, and A3

General Specifications

Maximum Conductor Size

19mm diameter

Output Connection

4mm safety connector

Output Zero

Manual adjust via thumbwheel

Cable length

1.5 meters

Operating Temperature Range

0°C to +50°C

Storage Temperature Range

-20°C to +85°C (with battery removed)

Operating Humidity

15% to 85% (non-condensing)

Weight

250g