| |
|
 |
Bath
Accessories -
Mechanical Support for Probes and Accessories |
|
|
|
|
Mechanical Support for Probes
When setting up a new calibration bath, you need a way to
suspend your probes in the bathy fluid. We recommend our
modular mechanical support systems. Made of fine-quality
steel and machined parts, these support components combine
in hundreds of ways to solve almost any probe suspension
problem.
|
 |
Mechanical
Support for Probes
When setting up a new calibration bath, you need a way to
suspend your probes in the bathy fluid. We recommend our
modular mechanical support systems. Made of fine-quality
steel and machined parts, these support components combine
in hundreds of ways to solve almost any probe suspension
problem.
Individual Hardware
Our selection of clamps and stands provides a simple way to
hold probes and thermometers in baths during calibration.
System components can be assembled in a number of ways to
suit individual needs. Select clamps, rods, bossheads, and
bases to fit individual needs. |
 |
Single Probe Kit
Our single probe kit is a good way to get started. It has one
medium clamp, one 10-inch rod, one bosshead, and one V-base
for holding one probe.
Economy Kit
Our economy kit includes two V-bases, one 29-inch stainless
steel rod, two 23-inch rods, five bossheads, two micro-clamps,
and one medium clamp. This will build a bench-mounted frame
for suspending one rod and three clamps over a bath opening.
Simply add to your setup as needed. Choose from any of the
listed accessories. |
|
|
|
|
Ordering Information |
|
Selected Kits |
Description |
Model |
|
Single Probe Kit |
Includes: one medium clamp, one
10-inch rod, one bosshead, and one V-base. |
Hart 2051 |
|
Economy Kit
|
Includes: two V-bases, one
29-inch stainless steel rod, two 23-inch rods, five
bossheads, two micro-clamps, and one medium clamp. |
Hart 2050
|
|
|
|
|
|
|
Individual Hardware |
|
Item |
Description |
Qty |
Model |
|
Micro-clamps |
Holds thermometers and probes
with diameters to 0.75-inch. |
2 |
2055 |
|
Medium clamps |
Holds diameters up to
1.75-inches. |
1 |
2056 |
|
Non-slip tape |
Increases grip on clamps and
bossheads. |
1 |
2057 (roll) |
|
Stainless steel rods |
Used to assemble supports,
frameworks, or scaffolds. |
1 |
2058 10" |
| 1 |
2059 20" |
| 1 |
2060 23" |
| 1 |
2061 29" |
|
Bossheads |
Clamps two rods at right angles.
Also attaches clamps to rods. |
5 |
2062 |
|
Screw bases |
Holds one rod and is screwed to
the surface of your bench or bath lid.
2.5-inch diameter base; screws included. |
4 |
2063
|
|
V-base |
Holds one rod. Weighted for
excellent stability. 1kg (2.2 lbs). |
1 |
2064 |
|
Large V-base |
Same as above but larger.
Recommended for holding SPRTs and large probes. 2kg (4.4
lbs) (May be too large for some baths). |
1 |
2065 |
|
|
|
